All translations
Jump to navigation
Jump to search
Enter a message name below to show all available translations.
Found 2 translations.
| Name | Current message text |
|---|---|
| h German (de) | ==Geschwindigkeit Sanftanlauf (Punkt J)== Beim Aktivieren der Drehzahlregelung gibt das System nicht schlagartig Gas, sondern fährt die Rotorkopfdrehzahl langsam hoch, bis die gewünschte Vorgabedrehzahl erreicht ist. Der Parameter bei Einstellpunkt J bestimmt, wie schnell dieser Sanftanlauf beim erstmaligen Einschalten der Drehzahlregelung stattfindet. Die Geschwindigkeit wird in Umdrehungen angegeben, um die die Rotordrehzahl pro Sekunde erhöht wird. Je höher der Wert, desto schneller wird die Vorgabedrehzahl erreicht. Bitte beachte, dass die angegebenen Geschwindigkeiten nur Richtwerte sind - abhängig vom Ansprechverhalten des Motorstellers und der Trägheit des Rotorsystems kann es tatsächlich länger oder kürzer dauern, bis die gewünschte Drehzahl erreicht ist.<br /> <br /> {{TABLEV5/de|Geschwindigkeit Sanftanlauf |50 U/s |100 U/s |200 U/s |300 U/s |400 U/s }}<br /> <br /> Mit der StudioX Flow App kannst Du den Sanftanlauf deaktivieren, wobei der Wert auf "0" gesetzt wird. Das ist nötig, wenn der Motorsteller über einen eigenen Sanftanlauf verfügt (aber keine Drehzahlregelfunktion hat!). In diesem Fall gibt das System beim Einschalten sofort Halbgas und wartet, bis der Motorsteller die Drehzahl entsprechend hochgefahren hat, bevor es in den Drehzahlregelmodus umschaltet.<br /> <br /> {{WARNING_QUOTE|Bitte beachte, dass aus dem oben genannten Grund die Anlaufgeschwindigkeit über StudioX Flow nicht langsamer als 50 U/s eingestellt werden kann. Werte unter 50 haben dieselbe Wirkung wie der Wert 0, der Sanftanlauf ist dann also deaktiviert!}}<br /> <br /> |
| h English (en) | ==Slow rampup speed (J)== When using the internal Governor function, full throttle is not applied immediately when switching into idle up - instead the motor speed increases slowly until the desired headspeed is reached. At menu point J you can determine how fast this soft start occurs when the Governor is activated initially. The speed is given as the number of revolutions by which the rotor speed increases per second. The higher the value, the faster your preset headspeed will be reached. Please note that the given rates are only indicative - depending on the response of the speed controller and the inertia of the rotor system, it may actually take longer or shorter to reach the desired speed.<br /> <br /> {{TABLEV5|Slow rampup speed |50 rps |100 rps |200 rps |300 rps |400 rps }}<br /> <br /> With the StudioX Flow app you have the option to disable the soft start feature, which sets the ramp-up rate to "0". This is necessary when using a speed controller with a built-in soft start feature (but without headspeed governing!). In this case the system will add half throttle immediately and wait until the speed controller has finished its spool-up, then activate governing.<br /> <br /> {{WARNING_QUOTE|Please note that you can't set a speed lower than 50 rps in StudioX Flow because of the reason noted above. Setting the speed below 50 has the same effect as setting it to 0, i.e. it disables the soft start!}}<br /> <br /> |