All translations
Jump to navigation
Jump to search
Enter a message name below to show all available translations.
Found 2 translations.
| Name | Current message text |
|---|---|
| h German (de) | = Hinweise zum NANOBEAST = '''NANOBEAST''' unterstützt derzeit keine Telemetriesensoren. Ab Firmware-Version v5.10.x kann der Telemetrie-Rückkanal am SYS-Anschluss jedoch in Verbindung mit ELRS/CRSF-, JETI EXBus- oder Spektrum SRXL2-Empfängern genutzt werden, um das NANOBEAST direkt vom Sender aus zu konfigurieren. Weitere Informationen hierzu findest Du im Abschnitt zum [[Manuals:BXFbl:Setupmenu_intro:EDGETX/en|EdgeTX-Lua-Skript]].<br /> <br /> Die unten aufgeführten Parameter sind beim NANOBEAST nicht verfügbar. Der SYS-Anschluss wird während des Erkennungsvorgangs des Empfängertyps automatisch auf bidirektionale Telemetrie-Kommunikation umgestellt! Geht innerhalb von 5 Sekunden nach dem Einschalten kein RC-Signal ein (z. B. weil der Sender ausgeschaltet ist), schaltet der SYS-Anschluss automatisch in den normalen Betriebsmodus zurück.<br /> <br /> <br /> |
| h English (en) | = Notes for NANOBEAST = '''NANOBEAST''' doesn't support telemetry sensors at this moment. Since firmware v5.10.x yon can only use the telemetry backlink at SYS port in combination with ELRS/CRSF, JETI EXBus or Spektrum SRXL2 receivers in order to remotely setup your NANOBEAST directly from the radio. See [[Manuals:BXFbl:Setupmenu_intro:EDGETX/en|EDGETX Lua Script section]] for further information.<br /> <br /> The parameters shown below won't be accessible on NANOBEAST. The SYS port will automatically be set to bi-directional telemetry communication during receiver type scan! If no RC signal arrives within 5 seconds of power-up (e.g. because the transmitter is switched off), the SYS port automatically falls back to normal operation.<br /> <br /> <br /> |