All translations
Jump to navigation
Jump to search
Enter a message name below to show all available translations.
Found 2 translations.
| Name | Current message text |
|---|---|
| h German (de) | {{QUOTE|Achte beim Verlegen der Kabel darauf, dass diese am MICROBEAST ULTRA zugspannungsfrei anliegen. Verlege sie in einer losen Schleife und befestige sie nach ca. 5 - 7cm am Chassis des Modells. Verwende in unmittelbarer Nähe zu der Stelle, an der die Kabel im MICROBEAST ULTRA eingesteckt sind, keinen Schrumpf- oder Gewebeschlauch um die Kabel zu bündeln oder zu ummanteln. Dies macht die Kabel steif und unflexibel und kann dazu führen, dass selbst geringste Vibrationen auf das MICROBEAST ULTRA übertragen werden.}}<br /> <br /> <br /> |
| h English (en) | {{QUOTE|When you route the wire leads in your model make sure that there is no tension passed to the MICROBEAST ULTRA. Make sure that MICROBEAST ULTRA is able to move freely, so no vibrations get passed onto the unit by the wire leads. It is not recommended to bundle or tie down the leads close to the MICROBEAST ULTRA. On the other hand the wires must be attached so that they are unable to move the MICROBEAST ULTRA during the flight caused by g-force. In particular, do not use any shrink tubing or fabric hose to bundle or encase the wiring in close proximity to the point at which the cables are plugged into the MICROBEAST ULTRA. This makes the cables stiff and inflexible and can cause vibrations being transmitted to MICROBEAST ULTRA.}}<br /> <br /> <br /> |