Translations:Manuals:BXFbl:Setupmenu N/3/en

Adjustment on the device

At first you have to enable the governor function at SETUP MENU point N. If not already done, enter SETUP MENU by pressing and holding the button from operation mode for at least 2 seconds, then release when Menu LED A lights solid. Then repeatedly press the button until Menu LED N lights up. At SETUP MENU point N you can toggle between three different options by tapping the rudder stick. The Status-LED indicates which option is currently active:

Status-LED	Governor mode
off	no governor - the RPM Governor is not used. All control commands on the throttle channel will be passed to the [THR] output directly.
red	electric governor - select this option if your helicopter is powered by an electric motor and an electric speed controller is plugged into output [CH5] of MICROBEAST PLUS/ULTRA. The device reads the speed signal from the speed controller or a phase sensor and controls the rotor speed accordingly. Note that the speed controller itself must not be operated in a (heli-specific) governor mode! The speed controller must process the incoming throttle signal and control the motor as directly and unfiltered as possible.
blue	nitro governor - with this option the system can govern the rotor speed of a helicopter with a nitro or gas engine. In this case the system controls the throttle servo connected to output [THR] and controls the carburetor of the engine. The motor speed is read from a magnetic or optical sensor that detects the rotation of the crankshaft, the clutch bell or the main gear.

In order to enable the governor function choose red or blue depending on the type of helicopter/drive system you're using. Then briefly press the button to skip to the GOVERNOR MENU (this will only appear when the governor function is used; when the governor is disabled - Status-LED off - you will exit SETUP MENU directly).