Translations:Manuals:MBPlusFblV5:Setupmenu intro/8/en
Basic setup with StudioXm
If not already done power up your radio and MICROBEAST PLUS and connect the BLE2SYS interface to the [SYS]. Then click "Connect button" on the start screen of StudioXm when the BLE2SYS is found (for further information refer to the StudioXm instructions). Wait until the data is loaded from the device and initialization sequence is finished. At first the system will calibrate to the radio system, Menu LEDs H to N will cycle up and down at the device and you can read "Radio init" in the opening overview size. During this time do not move the sticks on your radio as the system is learning the stick mid positions. In the second step MICROBEAST PLUS checks if the sensors are working correctly and learns the sensor rest positions. Here Menu LEDs A to G will cycle up and down and you can read "Sensor init" in the opening overview size. During this time do not move the helicopter. When initialization is completed the Status LED will change to blue or purple color indicating the current gyro mode and you can read the gyro gain and mode in the App. If you can't get through the initialization sequence either because LEDs A-G or LEDs H-N don't stop cycling please read the FAQ. Note that during initialization pressing the button has no significant effect and you will not be able to enter any menu.
From the device overview page choose Basic heli setup to enter the setup wizard which will lead through the basic setup procedure of the SETUP MENU (note that the menu is only accessible after all settings have been loaded from the device and when the device is in operation mode). The adjustment is basically done using the buttons or dials in the app, sometimes interaction from your transmitter sticks are necessary. Click next or previous at the bottom of each setup step to skip to the following setup menu point. From the dropdown list at the top also you can directly access specific setup items if necessary. Adjustment procedure in short words is described at each step. If necessary refer to this manual if you need further assistance. When the setup is finished click the Home button in the top left corner to get back to the overview screen or disconnect the device and deactivate the BLE2SYS module by clicking the Disconnect button in the top right corner when adjustment is finished completely.