Translations:Manuals:MBPlusFblV52:Receiver B/5/en

Manual function assignment

In case the function ordering of your radio system differs from the given tables below, you have to manually assign the channels/functions step by step. This is done by simply actuating the appropriate function on your transmitter at each of the Menu Points B to I (J for devices with AttitudeControl/rescue). Each menu point represents one control function.

When you move the control stick/adjust the channel with the transmitter, the flashing Status LED indicates that the channel has been detected. It is important that only one channel moves on the radio whe the requested function is activated. Otherwise MICROBEAST PLUS can't recognize the desired channel. The Status LED will not flash in this case! If you have moved the wrong stick/switch, just move the correct one afterwards. MICROBEAST PLUS remembers only the last function that was operated and confirms it with blue flashing of the Status LED!

Move the collective at Menu Point B, then push the button when Status LED flashes

After teaching each function, briefly press the button to save the assignment and to skip to the next function. Once a channel was assigned, it is no longer available and is ignored by MICROBEAST PLUS for the remaining process! Thus, after learning of the collective pitch function at Menu Point B you can enable the throttle function (remove throttle hold) and teach the throttle channel later at Point G by re-operating the thrust stick there. The collective pitch channel no longer be considered as this channel has already been assigned previously.

The first 6 functions must be assigned as they are necessary for the basic flight control and the button remains locked until you operate a new control function. The other functions are optional to assign and can be skipped. If special features like AttitudeControl or Headspeed Governor are not installed on your device, the specific menu points for assignment will not be accessible at all.

• The assignment for Aux [CH6] Output at Menu Point H can be skipped by pressing the button without teaching a channel for this function in case it is not used.
• Likewise, the assignment of the channel for internal (nitro) governor can be skipped in case it is not needed or if you don‘t want to control the governor with a separate channel, e. g. if your transmitter does not provide enough free channels. By skipping the assignment the internal governor function will use a different operating mode that allows to control it via the throttle channel (set at Menu Point G) if you like. When used in an electric model the internal governor is controlled by the throttle channel (set at Menu Point G) in general. In this case the assignment at Menu Point I can be skipped anyway, as an assignment will have no effect.
• Finally at Menu Point J you have to assign the channel that is used to engage the AttitudeControl/rescue stabilization (only when you've installed the this feature on your device). Again, this can be skipped if not needed or if you don‘t want to use a separate channel (or in case you haven't enough free channels left). Please see the section about using AttitudeControl for further details.

Menu point	Function
B	Collective
C	Aileron
D	Elevator
E	Rudder
F	Tail gyro/Bank switch
G	Throttle [CH5]
H	Aux Output [CH6]
I	Governor control (nitro only)
J	AttitudeControl gain