Translations:Manuals:BXFbl:Setupmenu E/3/en

From BEASTX Wiki
Revision as of 14:17, 4 June 2024 by FuzzyBot (talk | contribs) (Importing a new version from external source)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Mechanical setup of the rudder servo

In the following of this setup step you will be asked to connect the rudder servo to your BEASTX device. With MICROBEAST PLUS/ULTRA the servo connects to [CH4] output. Watch out for correct polarity, the black or brown minus wire must be the clostest to the bottom of the device. Using NANOBEAST please connect the servo to [CH2] output. Here the servo polarity is similar to SPEKTRUM/Horizon Hobby servos, from inside to outside: signal, minus, plus.

 



Retrieved from "https://wiki.beastx.com/index.php?title=Translations:Manuals:BXFbl:Setupmenu_E/3/en&oldid=23830"