Translations:Manuals:BXFbl:Receiver A/7/en

From BEASTX Wiki
Revision as of 14:12, 8 September 2026 by FuzzyBot (talk | contribs) (Importing a new version from external source)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

NANOBEAST

Make sure the receiver is connected properly, bound to the radio and sending out signals, and that the transmitter is set up correctly. Espeically make sure the throttle is in lowest position (Motor off/full stop). Since firmware v5.9.11, RECEIVER MENU starts the automatic receiver detection routine on its own after 17 seconds when there is no valid receiver signal detected. The Status LED will indicate the scan process:

Retrieved from "https://wiki.beastx.com/index.php?title=Translations:Manuals:BXFbl:Receiver_A/7/en&oldid=26916"