Translations:Manuals:BXFbl:Receiver A/8/en

After power up the Status LED is flashing in red color slowly. When it lights up constantly, the receiver was found and the system is starting with sensor init phase. Skip the next sections in this case, all is up and running already!

If LED keeps blinking -> wait 17 seconds. The Receiver menu step A will be opened automatically and receiver scan process is initiated automatically. During scan process the Status LED color will change randomly. If your receiver was found the system will skip to Menu point N for setting throttle failsafe position. Status LED will be blue. Here move throttle to lowest position if not already done and wait until Status LED flashes blue. Then the system will restart automatically. Again you will see Status LED red slowly blinking. After few seconds it should change to solid red now, indicating the next step of init phase (sensor initialization).

When receiver scan fails, the Status Led will blink in red color once per seconds. Then the scan procedure will start over automatically again. In this case check connection of your receiver and make sure the radio transmitter is sending signals to the receiver (bound to the receiver).

Using a Spektrum DSMX remote satellite receiver, you must bind the receiver from NANOBEAST before usage. See DSMX receiver section for info about initiating bind procedure.