Update request

Update files for MICROBEAST, Trajectory and AR7200BX will be created exclusively for your device and mailed to the given address! To request an update the serial number for the device is necessary. Please have a look here, if you don't know where to find the serial number. The update files can be uploaded to the unit by using the update functionality of StudioX. Also you can get firmware updates directly from within StudioX 2.0 (see here).

Updating MICROBEAST PLUS can be directly done from within StudioX 2.0 only.

MICROBEAST PLUS

Current firmware versions available:

4.0.0
This version is an upgrade version that brings new features to your MICROBEAST PLUS device. At the moment there are
offered two versions: one with RPM Governor only and the full featured Pro-Edition with RPM-Governor and AttitudeControl.
As these versions enhance the functionality of MICROBEAST PLUS, we will charge some fee for these. Despite of the
additional features there is no functional difference to firmware version 3.2.0. So if you don't need the additional
features there is no must to buy them.

* The RPM Governor can be used for electric and glow helicopters. It has built in soft start and autorotation bail
  out function. The control it quite similar to electric speed controllers with governor function, so you simply set your
  throttle curves as switches for "motor off", "headspeed 1", "headspeed 2" and "autorotation bailout". Adjusting complex
  throttle curves is not necessary anymore and the helicopter will maintain the specified rotor head speed over the whole
  flight. Optional the nitro governor can be also used in classic style with throttle curves and a separate switch for
  governor/rpm control.

* AttitudeControl overs different modes of self leveling. These are "Bailout rescue mode", "3D-Mode" and "Flighttrainer
  mode" with angular limitation. Basically when you activate the AttitudeControl it will turn your helicopter back to
  level position when you release the sticks. Some modes additionaly apply collective pitch input and lock your thrust
  stick in the ground direction. So the unit will turn your helicopter and keep it leveled in hovering flight
  regardless of how the pilot moves the stick.  

3.2.0
 * supports new SRXL receiver types: Spektrum SRXL and Multiplex SRXL V2
 * added rudder servo sub trim feature
 * changed Status LED colors at Setup menu point M (Sensor directions) to be similar to MICROBEAST version 3.0.12
 * safety feature for Receiver setup menu: to change/setup receiver type and channel assignment you must go
   through the complete menu otherwise nothing will change

3.1.3
  * Bugfix: receiver channel initialisation could cause unit to start without stick control

MICROBEAST

Request Updates Files for the MICROBEAST here or download them directly with StudioX 2.0 (see here)

Current firmware version available:

3.0.12
  * Supports Graupner HOTT SUMD serial line signal
  * Improved receiver channel initialization
  * Improved tailgyro algorithm for normal (rate) mode

Trajectory

Request Updates Files for the Trajectory here or download them directly with StudioX 2.0 (see here)

Current firmware version available:

3.0.12 (similar to MICROBEAST)

AR7200BX

Request Updates Files for the AR7200BX here or download them directly with StudioX 2.0 (see here)

Current firmware versions available:

4.0.14
  * RPM Governor feature for nitro and gas engines
3.1.0 (similar to MICROBEAST firmware 3.0.12)