Translations:Studiox microbeast plus plugin/13/en

Advanced plugin configuration

From the StudioX main menu, open "Edit" then "Configure plugins..." to show the plugin Configuration dialog.
Select "MICROBEAST PLUS" from the list:

Serial Port Control

By default the MICROBEAST PLUS plugin will continuously try to query all serial interfaces (the USB2SYS/SPMA3030-Interface is a serial interface) to check if a MICROBEAST PLUS is connected somewhere.
Sometimes it is useful to limit the ports that the plugin is trying to query, i.e. in case a port is blocking the plugin. Therefore you can choose from one of the following options:

• Use all ports, except those selected
• Only use selected ports

Use the entries in the list below to refine your selection. The plugin will only try to query ports which match the selected rule.

Device Discovery

This specifies the interval time which is used to try identifying newly connected devices. This should not be modified if the mechanism is working properly.