Line 1: |
Line 1: |
| = Futaba SBUS2 = | | = Futaba SBUS2 = |
| + | Make sure you receiver is set up to send SBUS2 telemetry data. Usually this is done from the LINKAGE MENU of your Futaba radio. Sometimes it is necessary to perform a rebind, in order to activate the telemetry output!<br /> |
| + | <br /> |
| + | In the SENSOR menu activate the following devices:<br /> |
| + | * SLOT 8: rpm sensor (=headspeed) |
| + | * SLOTs 9-10-11: CUR-1678 (=voltage, current, consumption) |
| + | * SLOT 12: TEMP-1713 (=ESC temperature) |
| + | * SLOT 13: TEMP-1713 (=PWM) |
| + | <br /> |
| + | Please note this assignment is fixed. If you use additional sensors on the same slots, these must be reassigned to other slots.<br /> |
| + | <br /> |
| + | You can add alarms to each item in the TELEMETRY menu. Please refer to the instructions manual of your radio for further reference.<br /> |
| + | <br /> |
| <br /> | | <br /> |