Translations:Manuals:BXFbl:TelemetryInfo/5/en

GRAUPNER HOTT

Make sure your receiver is set up to send telemetry data on the external telemetry data output. This is usually done from the TELEMETRY MENU of your HOTT radio.

The telemetry data line is connected to the [SYS] port of your BEASTX System. For this type of application, you must set RECEIVER MENU point L to Status-LED blue (="HOTT").
See section "Telemetry" in RECEIVER MENU for additional information.

To get telemetry information on your radio's display, there is not much to do. Just make sure to switch on the radio and receiver simultaneously. If you open the TELEMETRY tab on the radio, you should see the "SEARCH" label, indicating that telemetry data is being received by the radio. After approx. 15 seconds, the radio should display telemetry data. Your BEASTX System simulates a HOTT EAM (Electric Air Module) and VARIO, so you will see the associated screens on the radio.