Translations:Manuals:BXFbl:TelemetryInfo/8/en

Futaba SBUS2 (MICROBEAST ULTRA only)

Make sure your receiver is set up to send SBUS2 telemetry data. This is usually done from the LINKAGE MENU of your Futaba radio. Sometimes it is necessary to perform a rebind in order to activate the telemetry output!

In the SENSOR menu, activate the following devices:

• SLOT 8: rpm sensor (=headspeed)
• SLOTs 9-10-11: CUR-1678 (=voltage, current, consumption)
• SLOT 12: TEMP-1713 (=ESC temperature)
• SLOT 13: TEMP-1713 (=PWM)

Please note this assignment is fixed. If you use additional sensors on the same slots, these must be reassigned to other slots.

You can add alarms to each item in the TELEMETRY menu. Please refer to the instruction manual of your radio for further reference.