Translations:Manuals:MBUltraFblV5:Parametermenu/2/en

Adjustment at the device

When MICROBEAST ULTRA is ready for operation, hold down the button until the Menu LED next to point A flashes quickly, then release the button immediately. The flashing menu LED A shows that you've entered menu point A of PARAMETER MENU. To skip to the setting you like to adjust, repeatedly press the button until the corresponding Menu LED flashes. The current setting of this menu point is shown by color and state of the Status LED. Tapping the rudder stick left/right you can decrease/increase the value. If you don't like to use one of the presets, you can edit each setting with the StudioX app to your likings. In this case when your custom setting does not match the presets the Status LED will stay 'off. You can still choose one of the presets by tapping the rudder stick, but this will erase your custom setting.

When using the bank switching feature (only with PROEDITION firmware) you can only change the settings for bank 1 using the LED menu of MICROBEAST ULTRA. The parameters for banks 2 and 3 must be set in the StudioX app. When disabling bank switching the settings will not change as bank 1 is used by default!