Translations:Manuals:MBUltraFblV5:Receiver A/3/en

Adjustment on the device

To get into the RECEIVER MENU press the button on MICROBEAST ULTRA and hold it down before(!) and while turning on the receiver power supply. The yellow Menu LEDs start to cycle immediately. When you release the button, Menu LED A will be flashing and the color of the Status LED will indicate the receiver type that is selected at the moment.

In order to detect the receiver you're using, make sure the receiver is connected properly, bound to the radio and sending out signals. Also make sure the transmitter is setup correctly as shown in the chapter Radio System. Then briefly press the button to start automatic receiver detection routine. The Status LED will indicate the scan process:

Status-LED	Receiver type/protocol
off	Standard receiver
purple	Receiver at remote port
red	No receiver detected
blue	Receiver at port IO1

• In case a single-line receiver is used, the system will skip to Menu Point B when a valid input signal was detected.
• When a Standard receiver is used, the system will exit and restart immediately.
• When detection fails, the system will stay at Menu Point A and the Status LED will flash in red color. Once again, make sure your receiver is connected properly to MICROBEAST ULTRA, make sure the receiver is bound to the transmitter and sending out control signals. Then please try again.