Translations:Manuals:MBUltraFblV5:Setupmenu D/3/en

Adjustment on the device

To select the desired servo frequency, move the rudder stick repeatedly in one direction until the Status-LED lights in the correct color at SETUP MENU point D. Please note that depending on the rudder servo pulse width chosen at Menu Point C, you may not be able to select 560Hz! Servos with Standard pulse width of 1500/1520µs can only run at maximum frame rate of 400Hz.

Status-LED	Rudder servo frequency
purple	50 Hz
red flashing	165 Hz
red	270 Hz
blue flashing	333 Hz
blue	560 Hz

Note: When you set a different frame rate with StudioX, the Status LED will be off. You can change back to a preset by tapping the rudder stick as described, but this will remove your custom setting!