Template:TOC MBPlusV5
From BEASTX Wiki
Revision as of 20:06, 8 April 2022 by Shornstein (talk | contribs)
{{#if: |MICROBEAST PLUS V5.{{{4}}}
- [[Manuals:MBPlusFblV5{{{4}}}:Intro/en|1. Introduction]]
- [[Manuals:MBPlusFblV5{{{4}}}:Safety/en|2. Safety notes]]
- [[Manuals:MBPlusFblV5{{{4}}}:Box_Content/en|3. Box content and accessories]]
- [[Manuals:MBPlusFblV5{{{4}}}:Hardware_Installation/en|4. Hardware installation]]
- [[Manuals:MBPlusFblV5{{{4}}}:Radio_System/en|5. Receiver connection]]
- [[Manuals:MBPlusFblV5{{{4}}}:Radio_Setup/en|6. Radio system]]
- [[Manuals:MBPlusFblV5{{{4}}}:ReceiverType/en|7. Receiver Menu]]
- [[Manuals:MBPlusFblV5{{{4}}}:Receiver_A/en|Receiver type]]
- [[Manuals:MBPlusFblV5{{{4}}}:Receiver_B/en|Function assignment]]
- [[Manuals:MBPlusFblV5{{{4}}}:Receiver_M/en|Telemetry input]]
- [[Manuals:MBPlusFblV5{{{4}}}:Receiver_N/en|Throttle failsafe]
- [[Manuals:MBPlusFblV5{{{4}}}:Setupmenu_intro/en|8. Basic setup]]
- [[Manuals:MBPlusFblV5{{{4}}}:Setupmenu_A/en|Device orientation]]
- [[Manuals:MBPlusFblV5{{{4}}}:Setupmenu_B/en|Swashplate servos]]
- [[Manuals:MBPlusFblV5{{{4}}}:Setupmenu_C/en|Rudder pulse width]]
- [[Manuals:MBPlusFblV5{{{4}}}:Setupmenu_D/en|Rudder frequency]]
- [[Manuals:MBPlusFblV5{{{4}}}:Setupmenu_E/en|Rudder control]]
- [[Manuals:MBPlusFblV5{{{4}}}:Setupmenu_G/en|Swash mixing]]
- [[Manuals:MBPlusFblV5{{{4}}}:Setupmenu_H/en|Servo directions]]
- [[Manuals:MBPlusFblV5{{{4}}}:Setupmenu_I/en|Cyclic directions]]
- [[Manuals:MBPlusFblV5{{{4}}}:Setupmenu_J/en|Servo trim]]
- [[Manuals:MBPlusFblV5{{{4}}}:Setupmenu_K/en|Cyclic throw]]
- [[Manuals:MBPlusFblV5{{{4}}}:Setupmenu_L/en|Collective pitch]]
- [[Manuals:MBPlusFblV5{{{4}}}:Setupmenu_M/en|Servo limit]]
- [[Manuals:MBPlusFblV5{{{4}}}:Governor/en|9. Headspeed Governor]]
- [[Manuals:MBPlusFblV5{{{4}}}:Setupmenu_N/en|Activating the governor]]
- [[Manuals:MBPlusFblV5{{{4}}}:Governormenu_A/en|Sensor test mode]]
- [[Manuals:MBPlusFblV5{{{4}}}:Governormenu_B/en|Throttle low position]]
- [[Manuals:MBPlusFblV5{{{4}}}:Governormenu_C/en|Throttle high position]]
- [[Manuals:MBPlusFblV5{{{4}}}:Governormenu_D/en|Transmitter setup]]
- [[Manuals:MBPlusFblV5{{{4}}}:Governormenu_E/en|Signal divider]]
- [[Manuals:MBPlusFblV5{{{4}}}:Governormenu_F/en|Main gear ratio]]
- 10. Additional settings
- [[Manuals:MBPlusFblV5{{{4}}}:Quicktrim/en|Trimming]]
- [[Manuals:MBPlusFblV5{{{4}}}:ControlStyle/en|Control style]]
- [[Manuals:MBPlusFblV5{{{4}}}:Parametermenu/en|Special parameters]]
- [[Manuals:MBPlusFblV5{{{4}}}:Gains/en|Gains]]
- [[Manuals:MBPlusFblV5{{{4}}}:AttitudeControl/en|11. AttitudeControl (Self leveling)]]
- [[Manuals:MBPlusFblV5{{{4}}}:BankSwitch/en|12. Bank Switching]]
- [[Manuals:MBPlusFblV5{{{4}}}:FactoryReset/en|13. Factory reset]]
- [[Manuals:MBPlusFblV5{{{4}}}:VersionInfo/en|14. Version information]]
| MICROBEAST PLUS V5
- 8. Additional settings
}}