Translations:Manuals:MBPlusFblV52:TailMotor/3/en
If you haven't already done so, first start the receiver menu/remote control setup via StudioX or directly on the Microbeast:
- Scan for your sum signal receiver, then assign functions by manual teaching or simply by loading the preset. See section ReceiverType for further instructions.
- The telemetry setup can be skipped if necessary.
- The "Motor off" / Failsafe position is crucial. Make sure to perform this step properly, otherwise the MICROBEAST will not know where the radio's "Motor off" position will. With tail motor this important to set correctly because the tail motor will only switch on when throttle is above 25% from lowest position!
For the Logo 200/OMP M2 heli the "Motor off" position must be around -1800. In order to reach this position, you usually have to turn the throw of the throttle channel on the remote control to -110 to -120%. During adjustment, the motor controller should arm and beep when the position is actually reached.