Translations:Manuals:MBPlusFblV52:TailMotor/6/en

The most important points here: Tail adjustment
First check the control direction of the remote control. Right = blue, left = red on the Microbeast or according to the display in StudioX. If the direction is wrong, reverse the control direction in the radio. There is no reverse function on the Microbeast. With "Tail motor" firmware direction is fixed!

The positions for idle, full throttle, motor off and hover throttle are all displayed in microseconds. Default values should fit the Logo 200. Feel free to “play” with the settings again here. If you click on the gear symbol at the bottom, you will be taken to the second page. Motor off position is there: 980µs; from around 1000µs the motor will start to turn. The motor off position is always active as long as the throttle channel for the main motor is below 25% on the radio. As soon as you turn on the main motor, also the tail motor will start to run in hovering position. When in the settings menu, the main motor won't run for safety reasons, so in theory, you may adjust the tail throttle slightly even when on the flying field. The hover position should be set so that the helicopter will not turn around during start and take off. You may have to try something that fits best...

The idle and full throttle positions cannot be tested in the StudioX menu, only adjusted. Idle speed should be selected so that the engine rotates very easily. You can use the Motor off setting to “search” for the position where the engine rotates very slightly, and then adopt it accordingly. Alternatively, you can go out of the menu completely and actually turn on the main motor and then just steer left and right to see how the tail motor behaves and how it is affected by minimum and maximum settings.