Translations:Manuals:BXFbl:Setupmenu B/8/en

When routing the wires in your model, ensure that there is no tension on the flybarless system. Allow the housing to move freely to prevent vibrations from being transmitted through the wires. It is not recommended to bundle or tie down the wires close to the system. Lay out the wires loosely for a few inches, then attach them to the helicopter so they cannot move due to G-force. Additionally, avoid using shrink tubing to bundle or encase the wiring near the point where the cables are plugged into the BEASTX system. This can make the cables stiff and inflexible, leading to vibrations.