Firmware version

From BEASTX Wiki
Revision as of 11:39, 10 August 2024 by FuzzyBot (talk | contribs) (Updating to match new version of source page)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

MICROBEAST ULTRA V5

1. Introduction

2. Safety notes

3. Box content and accessories

4. Hardware installation

5. Receiver connection

6. Radio system

7. Receiver Menu
Receiver type
Function assignment
Telemetry input
Throttle failsafe
8. Basic setup
Device orientation
Swashplate servos
Rudder pulse width
Rudder frequency
Rudder control
Swash mixing
Servo directions
Cyclic directions
Servo trim
Cyclic throw
Collective pitch
Servo limit
9. Headspeed Governor
Activating the governor
Sensor test mode
Throttle low position
Throttle high position
Transmitter setup
Signal divider
Main gear ratio
10. Parameters
Gain adjustment
Trimming
Control style
Special parameters
11. Optional features
AttitudeControl (setup)
AttitudeControl (usage)
Bank Switching
Telemetry

12. Factory reset

13. Version information

14. Firmware update

← →


Firmware version

Please note that these instructions are only valid for BEASTX devices with firmware version 5.9.x and above!


Click here for firmware version changelog.



StudioX app

The firmware version can be detected by connecting your device with the StudioX App.


LED display

Using MICROBEAST PLUS or MICROEBAST ULTRA you can directly read from the LED display of the device what firmware version it is running. After power up when the Status-LED lights in red color, for a few seconds the Menu-LEDs A to G display the first digit of the firmware version and the LEDs H to N indicate the

second digit.


Version 5.9.x


Radio display

If using a SPEKTRUM or JETI telemetry radio you can read the firmware version from the radio display.



Retrieved from "https://wiki.beastx.com/index.php?title=Manuals:BXFbl:Version/en&oldid=25376"