Translations:StudioXm:Connection/14/en

Since BEASTX firmware version 5.9.x, it is possible to connect a telemetry receiver to the [SYS] port to transfer telemetry data and menu settings to and from the BEASTX device (EXBUS/SBUS2/F.Port). In order to connect the interface for the StudioX app, you can temporarily remove the receiver and connect the SYS interface to the [SYS] port. However, in this case, it may not be possible to control the system from the radio in the StudioX menus! As a workaround, connect the USB2SYS/BLE2SYS interface to the side of your MICROBEAST PLUS/MICROBEAST ULTRA instead of using the [SYS] port. This will require an adapter from the standard servo connector to the JST 6-pin format. Using EXBUS telemetry with NANOBEAST you can connect the EXBUS receiver to the DI port temporarily, so you can connect your interface to SYS port and will be able to use radio control for the setup. Using a CRSF receiver simply disconnect the TX line from SYS port and make sure the radio transmitter is OFF before powering up your BEASTX device. Then after 5 seconds power ON your transmitter. In this case the telemetry will be disabled on SYS port and you can connect your interface for configuration with StudioX Flow app while still be able to control the helicopter with the radio.