MICROBEAST does not finish initialization. What can I do?

From BEASTX Wiki
Revision as of 20:07, 9 December 2013 by Shornstein (talk | contribs)
Jump to navigation Jump to search
  • Watch the running LED lights during the init phase: If the lights A - G light up the sensor's rest positions are beeing calibrated. H - N show determining the RC channels and their center positions. Initially, the chase is from A - N. If a step is done, the light passes only between A - G or H - N. Can one step not be completed, either the unit is not receiving a valid signal or the MB was moved during the process (e.g. due to wind, vibrations, etc..).


  • Check whether the receiver sends control signals and that all cables are properly connected to the MICROBEAST. In particular make sure the plugs are inserted with correct polarity and not offset to the pin connectors of the MICROBEAST.


  • Only applies to Microbeast with firmware V2.0.0 and up: Is the correct type of receiver selected in the receiver setup menu?
Retrieved from "https://wiki.beastx.com/index.php?title=MICROBEAST_does_not_finish_initialization._What_can_I_do%3F&oldid=48"