Bureaucrats, Administrators, translate-proofr
15,511
edits
Changes
Jump to navigation
Jump to search
Line 37:
Line 37: − + + + + + + + + + + + + + + + + + + + + + + + +
no edit summary
<!--T:9-->
<!--T:9-->
<br />
<br />
The name COM3 may be different on your PC. This entry must disappear when you disconnect the USB2SYS-Interface from the PC and re-appear when you connect it again.
The name COM3 may be different on your PC. This entry must disappear when you disconnect the USB2SYS-Interface from the PC and re-appear when you connect it again.<br />
If there is only an entry marked with an yellow "!" something went wrong and you have to install the driver files manually which will be described in the following step 3.
If there is only an entry marked with an yellow "!" something went wrong and you have to install the driver files manually which will be described in the following step 3.
[[File:File:Device mgr failed.png|200px|thumb|none]]
<br />
<!--T:10-->
<!--T:10-->
'''4. Manual installation of USB2SYS interface driver'''
'''4. Manual installation of USB2SYS interface driver'''
First of all make sure the USB2SYS interface is disconnected from the computer. Then start the StudioX Software and click the download link for the USB2SYS driver package:
[[File:Driver download page.png|200px|thumb|none]]
<br />
Your web browser will open and ask to save the file "CP210x_VCP_Windows.zip" or will save it automatically. Open the downloaded zip-file from the folder where it has been saved to and extract the content of the file to your harddisk (here we directly extract it to drive C:). Go to the extracted folder and start one of the included setup files (if you have a 64-bit Windows use the "CP210xVCPInstaller_x64.exe", if you have a 32-bit system use CP210xVCPInstaller_x86.exe).
<gallery>
File:Driver file.png
File:Extract driver.png
File:Extract driver2.png
File:Extract driver3.png
</gallery>
<br />
Proceed through the installer by accepting the license agreement and clicking "Next" and "Install".
<gallery>
File:SiLabs1.png
File:SiLabs2.png
File:SiLabs3.png
File:SiLabs4.png
</gallery>
<br />
When the installation was finished, connect the USB2SYS interface to the computer (again). That's it, your interface should now appear correctly in device manager (see above) and you can use the assigned COM port to connect to your MICROBEAST/Ar7xxxBX device.
<!--T:11-->
<!--T:11-->