7,270
edits
Changes
Jump to navigation
Jump to search
Line 14:
Line 14: − ===3. Driver installation===+ − Windows: − The driver installation will not be launched automatically during setup. − The installer will be copied and a link to it is added to the BEASTX group in Start-Menu. Do not connect the USB2SYS interface to the computer unless you did not perform the driver installation. After the installation when you connect the interface to the PC, Windows will recognize the device and install it as a new device. Line 38:
Line 35: − ===5. Start BEASTXUpdater===+ − IMPORTANT: The MICROBEAST will not be powered from the USB2SYS-Interface, so the MICROBEAST must be supplied with power from a different source BEFORE you connect it to the PC, e.g. simply switch on tx and rx as you would go flying (on electric helis take care of the motor!). Line 113:
Line 109: − ===8. Perform Update===+ − If a valid COM-Port is selected an a valid Update-File was loaded, the "Start Update…" button will be enabled:
Importing a new version from external source
'''3. Driver installation'''
Windows:
Windows:
'''5. Start BEASTXUpdater'''
IMPORTANT: The MICROBEAST will not be powered from the USB2SYS-Interface, so the MICROBEAST must be supplied with power from a different source BEFORE you connect it to the PC, e.g. simply switch on tx and rx as you would go flying (on electric helis take care of the motor!).
IMPORTANT: The MICROBEAST will not be powered from the USB2SYS-Interface, so the MICROBEAST must be supplied with power from a different source BEFORE you connect it to the PC, e.g. simply switch on tx and rx as you would go flying (on electric helis take care of the motor!).
'''8. Perform Update'''
If a valid COM-Port is selected an a valid Update-File was loaded, the "Start Update…" button will be enabled:
If a valid COM-Port is selected an a valid Update-File was loaded, the "Start Update…" button will be enabled: