Bureaucrats, Administrators, translate-proofr
15,511
edits
Changes
Jump to navigation
Jump to search
Line 21:
Line 21: + + + + + + +
no edit summary
To enter one of the menus you have to wait until the unit did perform the self test and did fully initialize: The Status LED must get blue or purple and the cycling LEDs A to G and H to N must have stopped.
To enter one of the menus you have to wait until the unit did perform the self test and did fully initialize: The Status LED must get blue or purple and the cycling LEDs A to G and H to N must have stopped.
Factory reset only can be performed when being within Setup menu. So you have at least to get to Setup menu point '''A''' (or later), release the button and then push it and keep it pushed for at least 10 seconds. Note that factory reset will only revert all parameters of parameter menu and setup menu to default. It has no influence on receiver menu parameters. If the unit does not initialize due to wrong receiver setting the factory reset will not help. In such case also have a look here.
Factory reset only can be performed when being within Setup menu. So you have at least to get to Setup menu point '''A''' (or later), release the button and then push it and keep it pushed for at least 10 seconds. Note that factory reset will only revert all parameters of parameter menu and setup menu to default. It has no influence on receiver menu parameters. If the unit does not initialize due to wrong receiver setting the factory reset will not help. In such case also have a look here.
===Selection in the menus with the rudder control stick does not work.===
Maybe there is not enough movement or any movement at all on the rudder channel.
* Check servo throw and dual rate setting for the rudder channel in the transmitter and increase the throw.
* Receiver type "Standard": Check that the connector for the rudder channel (orange wire) is inserted correctly in the receiver.
* Is the correct stick moved? Check stick mode of transmitter and have a look at the servo monitor. Is there any movement on the channel that you have connected the orange wire for rudder function to (Receiver type "Standard")?
* Serial-wire receiver: Was the rudder channel assigned for rudder function at [[Manuals:MB_Plus:Receiver_setup_menu_B|receiver setup menu]]?
===Setup menu points B to D - What are frequency and neutral pulse for a specific servo?=== <!--T:4-->
===Setup menu points B to D - What are frequency and neutral pulse for a specific servo?=== <!--T:4-->