Bureaucrats, Administrators, translate-proofr
15,511
edits
Changes
Jump to navigation
Jump to search
Line 67:
Line 67: − + − Please check whether everything works properly on the ground. When giving collective pitch input the swash should move up and down properly. When giving cyclic input it should return to zero after a few seconds. This is also especially after turning on Idle up or switching between flight conditions in the transmitter. Make sure that there are no trims, mixers, etc. in any flight condition and also make sure that the sensor directions for aileron and elevator are setup correctly (Setup menu point M)!+ +
Created page with "===Der Helikopter neigt sich beim Start zur Seite oder dreht im Flug auf einer Achse weg=== * Bitte prüfen Sie ob im Stand alles einwandfrei funktioniert, beim Pitchgeben di..."
==Flugverhalten==
==Flugverhalten==
===Helicopter tips over when trying to take off or tilts to one side in flight.===
===Der Helikopter neigt sich beim Start zur Seite oder dreht im Flug auf einer Achse weg===
* Bitte prüfen Sie ob im Stand alles einwandfrei funktioniert, beim Pitchgeben die TS also sauber nach oben und unten läuft und dies insbesondere auch noch nach Einschalten der Drehzahl/Umschalten der Flugphase im Sender der Fall ist. Also keine Trimmungen, Mischer, etc.
When taking off do not use too much cyclic input. Just let the motor come up to speed and then quickly give pitch input. Only when the helicopter is airborne the system can operate and control commands. If the helicopter sits on the ground, however, a stick input(= command to rotate the heli) would have no effect and the system would increase the cyclic pitch more and more desperately to perform a rotational movement. As soon as the helicopter will get "light" by increasing the collective pitch it will tip over abruptly. So always make sure that the swash is aligned straight during starting procedure!
When taking off do not use too much cyclic input. Just let the motor come up to speed and then quickly give pitch input. Only when the helicopter is airborne the system can operate and control commands. If the helicopter sits on the ground, however, a stick input(= command to rotate the heli) would have no effect and the system would increase the cyclic pitch more and more desperately to perform a rotational movement. As soon as the helicopter will get "light" by increasing the collective pitch it will tip over abruptly. So always make sure that the swash is aligned straight during starting procedure!