7,261
edits
Changes
Jump to navigation
Jump to search
Line 2:
Line 2: + + + + + + + + Line 21:
Line 29: − NOTE: This procedure can lead to damage and severe injury if not obtaining safety rules.+
Updating to match new version of source page
<br />
<br />
<br clear="right" />
<br clear="right" />
==Receiver menu==
===Spektrum AR9020 SRXL/XPlus signal output===
''I'm using firmware 3.2.0 (or greater) which is stated to support Spektrum SRXL/XPLus serial wire signal but MICROBEAST PLUS does not recognize my AR9020 receiver at receiver menu point B (Status LED stays red).''
Unfortunately the communication protocol of the AR9020 receiver is not fully compatible to the SRXL specification. We can provide a MICROBEAST PLUS firmware with modified Spektrum SRXL protocol so that the AR9020 receiver's SRXL output can be used anyway. You can request the firmware at our [mailto:service@beastx.com service center]. When using this firmware it is not possible to use receivers from Multiplex-RC with SRXL V2 signal output, neither is it possible to use Spektrum receivers that are compliant with SRXL standards. Otherwise this modified firmware does not differ from the default firmware.<br />
<br />
==Setup==
==Setup==
: If using a digital servo it definitely should be capable of more than 65Hz. So if we have a unknown servo we carefully increase framerate step by step by testing on the workbench and then fly shortly and check servo temperature very often. If there are no abnormalities like extreme heat production we again increase the framerate and again test carefully.
: If using a digital servo it definitely should be capable of more than 65Hz. So if we have a unknown servo we carefully increase framerate step by step by testing on the workbench and then fly shortly and check servo temperature very often. If there are no abnormalities like extreme heat production we again increase the framerate and again test carefully.
NOTE: This procedure can lead to damage and severe injury if not obtaining safety rules.
If you want to be on the safe side go with 65Hz unless the manufacturer doesn't give you another classification.
If you want to be on the safe side go with 65Hz unless the manufacturer doesn't give you another classification.
We cannot tell you the specs of a servo unless we don't have any data of this specific servo ourselves. Please ask
We cannot tell you the specs of a servo unless we don't have any data of this specific servo ourselves. Please ask