7,261
edits
Changes
Jump to navigation
Jump to search
Line 71:
Line 71: − + + + + +
Importing a new version from external source
* Check whether the receiver sends out control signals and that all cables are properly connected to the MICROBEAST/MICROBEAST PLUS. In particular make sure the plugs are inserted with correct polarity and not offset to the pin connectors of the MICROBEAST.
* Check whether the receiver sends out control signals and that all cables are properly connected to the MICROBEAST/MICROBEAST PLUS. In particular make sure the plugs are inserted with correct polarity and not offset to the pin connectors of the MICROBEAST.
* MICROBEAST/MICROBEAST PLUS Version 2.0.0 and greater: Is the correct type of receiver selected in the receiver setup menu? See [[Setup receiver type - Microbeast, Trajectory]]
* Is the correct type of receiver selected in the [[Manuals:MB_Plus:Receiver_setup_intro|receiver setup menu]]? Particularly when using a Spektrum® radio system note that receivers like Spektrum® AR6100, 7000, 9000 etc. are "Standard" receivers! The selection of "Spektrum®" in the receiver setup menu only applies for direct connection of one single Spektrum satellite with the optional available adapter. In general when using a serial-wire receiver check if the Status-LED lights up in "blue" color at [[Manuals:MB_Plus:Receiver_setup_menu_B|Receiver setup menu point '''B''']] indicating there is a valid signal coming from the receiver.
* When using a Standard receiver check the wiring. Mainly check receiver wires for polarity on both sides and correct plugging (no vertical offset by one pin).
* MICROBEAST/MICROBEAST PLUS: Check binding between transmitter and receiver.
* AR7200BX/AR7300BX: Check binding between transmitter and receiver.<br />
<br />
* AR7200BX: Check binding between transmitter and unit.
* AR7200BX: Check binding between transmitter and unit.