7,227
edits
Changes
Jump to navigation
Jump to search
Line 64:
Line 64: + + + +
Importing a new version from external source
<br />
<br />
2) Stick is commanding a rotation even when it seems to be in center position. Check all your trimmings on the transmitter. They must be 0 in all flight modes. Make sure to keep the sticks centered during power up as the system learns stick center positions each time it performs the init sequence. This is necessary because most often stick potentiometer positions vary slightly, i.e. due to different ambient temperature. This issue can solved by using stick deadband but to keep deadband as low as possible and to increase overall performance MICROBEAST / MICROBEAST PLUS learns stick position directly before flying. However, if you see your sticks do not center properly, i.e. when pushing and releasing the stick softly the servo starts to creep into one direction and only will stop when tapping the stick into the opposite direction, then you can increase the Stick Deadband at Parameter menu point E.<br />
2) Stick is commanding a rotation even when it seems to be in center position. Check all your trimmings on the transmitter. They must be 0 in all flight modes. Make sure to keep the sticks centered during power up as the system learns stick center positions each time it performs the init sequence. This is necessary because most often stick potentiometer positions vary slightly, i.e. due to different ambient temperature. This issue can solved by using stick deadband but to keep deadband as low as possible and to increase overall performance MICROBEAST / MICROBEAST PLUS learns stick position directly before flying. However, if you see your sticks do not center properly, i.e. when pushing and releasing the stick softly the servo starts to creep into one direction and only will stop when tapping the stick into the opposite direction, then you can increase the Stick Deadband at Parameter menu point E.<br />
<br />
==After updating MICROBEAST PLUS from Version 3.x.x to Version 4.x.x. the collective pitch does not work correctly anymore==
As version 4.x.x can be upgraded with the AttitudeControl functionality it is required to set up thrust stick directions. Firmware Version 3.x.x did not provide such parameters therefore you must set the thrust stick positions by adjusting the collective pitch at Setup menu point K. Otherwise you can only control collective pitch into one direction. '''Please read the [http://www.beastx.com/download/manual/microbeast/BeastX_ProEdition_V4.0.0_EN_0715.pdf MICROBEAST PLUS ProEdition Addon manual] carefully. There are also a few other things that are different to Version 3.x.x and that need to be readjusted.'''<br />
<br />
<br />