7,241
edits
Changes
Jump to navigation
Jump to search
Line 56:
Line 56: + + + + + + + + + + + + + + + + + + + + +
Importing a new version from external source
<br />
<br />
{{WARNING_QUOTE|When updating from firmware 4.x.x or lower to Version 5.x.x you will loose all your settings. Please carefully read the Version 5 instruction manual and do the basic setup again.}}<br />
{{WARNING_QUOTE|When updating from firmware 4.x.x or lower to Version 5.x.x you will loose all your settings. Please carefully read the Version 5 instruction manual and do the basic setup again.}}<br />
<br />
'''5.1.2 PROEDITION'''<br />
:''Tail gyro''
:* center rudder servo when heli is on gound by giving brief stick input "left-right-left-center"
<br />
:''Governor''
:* improved performance of governor in nitro and electric mode
:* no throttle lock at full speed when headspeed does not increase fast enough in nitro mode
:* use logging feature to get more insight what the governor actually does, i.e. it will tell you that chosen head speed is too high when head speed can't be reached or only can be reached at nearly maximum throttle
<br />
:''AttitudeControl''
:* when using Bank Switching and AttitudeControl with separate switch channel you can now do both, set fixed AttitudeGain in a bank or use the separate switch. So AttitudeControl is always active in this bank when the gain is set to greater than 12 by software. When it is set to 0, the separate switch will determine when AttitudeControl is on or off.
<br />
:''Setup''
:* at SETUP POINT K (Pitch adjustment) you can see the actual thrust stick center position when the Status LED is off. You can use this to identify a little stick offset which may cause your pitch not being at 0 degrees when the stick seems to be in center position!
:* added visualization when performing a factory reset
:* increased Quick trim range
<br />
:''StudioX''
:* added data logging to be viewed in StudioXm and StudioX V3 (Note: log data is only temporary and will be erased when removing power from the device!)
:* added possibility to perform factory reset by software<br />
<br />
<br />
'''5.0.4 PROEDITION'''<br />
'''5.0.4 PROEDITION'''<br />