7,241
edits
Changes
Jump to navigation
Jump to search
Line 57:
Line 57: − + Line 66:
Line 66: − + + Line 73:
Line 74: + + +
Importing a new version from external source
{{WARNING_QUOTE|When updating from firmware 4.x.x or lower to Version 5.x.x you will loose all your settings. Please carefully read the Version 5 instruction manual and do the basic setup again.}}<br />
{{WARNING_QUOTE|When updating from firmware 4.x.x or lower to Version 5.x.x you will loose all your settings. Please carefully read the Version 5 instruction manual and do the basic setup again.}}<br />
<br />
<br />
'''5.1.2 PROEDITION'''<br />
'''5.1.2'''<br />
:''Tail gyro''
:''Tail gyro''
:* center rudder servo when heli is on gound by giving brief stick input "left-right-left-center"
:* center rudder servo when heli is on gound by giving brief stick input "left-right-left-center"
:* use logging feature to get more insight what the governor actually does, i.e. it will tell you that chosen head speed is too high when head speed can't be reached or only can be reached at nearly maximum throttle
:* use logging feature to get more insight what the governor actually does, i.e. it will tell you that chosen head speed is too high when head speed can't be reached or only can be reached at nearly maximum throttle
<br />
<br />
:''AttitudeControl''
:''AttitudeControl (stabilization) (PROEDITION only)''
:* when using Bank Switching and AttitudeControl with separate switch channel you can now do both, set fixed AttitudeGain in a bank or use the separate switch. So AttitudeControl is always active in this bank when the gain is set to greater than 12 by software. When it is set to 0, the separate switch will determine when AttitudeControl is on or off.
:* when using Bank Switching and AttitudeControl with separate switch channel you can now do both, set fixed AttitudeGain in a bank or use the separate switch. So AttitudeControl is always active in this bank when the gain is set to greater than 12 by software. When it is set to 0, the separate switch will determine when AttitudeControl is on or off.
:* in 3D - Mode you can enable/disable stabilization when the heli is in exact vertical position, so you may be able to practice maneuvers in which the heli is nearly upright more easily, i.e. funnels or hurricanes
<br />
<br />
:''Setup''
:''Setup''
:* added visualization when performing a factory reset
:* added visualization when performing a factory reset
:* increased Quick trim range
:* increased Quick trim range
<br />
:''Receivers''
:* using SRLX receivers the internal function assignment of MICROBEAST PLUS was not similar to the transmitter display/function assignment of the radio manufacturers, this has been changed so that Microbeast uses different assignments for each manufacturer. (Please note: due to this update you will have to do the radio setup and function assignments once again after the firmware update to version 5.1.2 when using a SRLX receiver)
<br />
<br />
:''StudioX''
:''StudioX''