Bureaucrats, Administrators, translate-proofr
15,511
edits
Changes
Jump to navigation
Jump to search
Line 1:
Line 1: + − + Line 22:
Line 23: − +
Marked this version for translation
__TOC__
__TOC__
<translate>
<translate>
<!--T:1-->
{{DISPLAYTITLE:Powerup and initialization|noerror}}
{{DISPLAYTITLE:Powerup and initialization|noerror}}
<br />
<br />
==MICROBEAST does not finish initialization. What can I do?==
==MICROBEAST does not finish initialization. What can I do?== <!--T:2-->
Watch the running LED lights during the init phase: If the lights A - G light up the sensor's rest positions are being calibrated, H - N show determining the RC channels and their center positions.
Watch the running LED lights during the init phase: If the lights A - G light up the sensor's rest positions are being calibrated, H - N show determining the RC channels and their center positions.
MICROBEAST/AR7x00BX: Initially the chase is from A - N. If one step is done the indication light for this step will quit running.
MICROBEAST/AR7x00BX: Initially the chase is from A - N. If one step is done the indication light for this step will quit running.
<br />
<br />
==The brand new MICROBEAST only shows a red flashing LED, random LED sequence or even nothing. What's wrong?==
==The brand new MICROBEAST only shows a red flashing LED, random LED sequence or even nothing. What's wrong?== <!--T:3-->
Check very carefully that all cables are plugged in correctly and all the plugs are connected properly at the correct position on both MICROBEAST and receiver side. Especially in the vertical direction make sure not just 2 pins sit on the header. Also make sure that the polarity is correct on all connections. Make sure your power supply (BEC or receiver battery) is capable to power all connected devices (servos, receiver, flybarless). When the power drain is too high this can cause a short drop in voltage making the system resart over and over again.<br />
Check very carefully that all cables are plugged in correctly and all the plugs are connected properly at the correct position on both MICROBEAST and receiver side. Especially in the vertical direction make sure not just 2 pins sit on the header. Also make sure that the polarity is correct on all connections. Make sure your power supply (BEC or receiver battery) is capable to power all connected devices (servos, receiver, flybarless). When the power drain is too high this can cause a short drop in voltage making the system resart over and over again.<br />
<br />
<br />
</translate>
</translate>