Bureaucrats, Administrators, translate-proofr
15,683
edits
Changes
Jump to navigation
Jump to search
Line 2:
Line 2: − + + + Line 9:
Line 11: − + + + + − −
no edit summary
<!--T:1-->
<!--T:1-->
{{DISPLAYTITLE:Nanobeast and Shape S2 FAQ|noerror}}
{{DISPLAYTITLE:Nanobeast and Shape S2 FAQ|noerror}}
[[File:Nanobeast.png|thumb|250px|right]]
[[File:Nanobeast.png|200px|left]]<br />
<br clear=all>
<br />
= External programming device for nanobeast / Shape S2 heli = <!--T:2-->
= External programming device for nanobeast / Shape S2 heli = <!--T:2-->
FYI: In fact only the push button on the device is needed. The 3 DIP switches are no in use with current firmware and may be used for other programming tasks in future.<br />
FYI: In fact only the push button on the device is needed. The 3 DIP switches are no in use with current firmware and may be used for other programming tasks in future.<br />
<br />
<br />
Additional note: The programming button can be used in combination with the standard nanobeast firmware in order to initiate automatic receiver scan, too. Please refer to the [https://www.beastx.com/download/manual/nanobeast/ShapeS2_Handbuch_V101_web.pdf Shape S2 instruction manual] Shape S2 instruction manual] (basically procedure is as follows: connect programmer, power up, push and hold button while LED is flashing red, release when LED goes out, again push briefly to start scan).<br />
Additional note: The programming button can be used in combination with the standard nanobeast firmware in order to initiate automatic receiver scan, too. Please refer to the [https://www.beastx.com/download/manual/nanobeast/ShapeS2_Handbuch_V101_web.pdf Shape S2 instruction manual] (basically procedure is as follows: connect programmer, power up, push and hold button while LED is flashing red, release when LED goes solid, again push briefly to start scan).<br />
<br />
<br />
[[File:Nanobeast_Programming.PNG|x300px|border]]<br />
<br />
<br />
</translate>
</translate>