* The BLE2SYS interface must be connected to the SYS port; watch out for correct polarity! Make sure the LED on the BLE2SYS flashes in intervals of 2 seconds. By default the interface deactivates after 30 seconds when there is no connection. In this case the LED is off. You have to cylce power in order to reactivate the device. | * The BLE2SYS interface must be connected to the SYS port; watch out for correct polarity! Make sure the LED on the BLE2SYS flashes in intervals of 2 seconds. By default the interface deactivates after 30 seconds when there is no connection. In this case the LED is off. You have to cylce power in order to reactivate the device. |