7,241
edits
Changes
Jump to navigation
Jump to search
Line 25:
Line 25: − + Line 45:
Line 45: − + − + +
Updating to match new version of source page
<br />
<br />
==StudioX does not recognize my device==
==StudioX (Version 2.x.x) does not recognize my device==
''I start the StudioX software and connect my BEASTX device to the computer but nothing happens.''
''I start the StudioX software and connect my BEASTX device to the computer but nothing happens.''
* Make sure the wiring is connected correctly. The servo wire coming from the USB interface goes into SYS port on your MICROBEAST / AR7xxxBX device. Watch out for correct polarity and '''make sure that the device is powered from a receiver battery or BEC''' (only when using the RX2SIM interface the BEASTX device can be powered from the USB port!).
* Make sure the wiring is connected correctly. The servo wire coming from the USB interface goes into SYS port on your MICROBEAST / AR7xxxBX device. Watch out for correct polarity and '''make sure that the device is powered from a receiver battery or BEC''' (only when using the RX2SIM interface the BEASTX device can be powered from the USB port!).
==StudioXm does not find the BLE2SYS bluetooth interface when refreshing the interface list==
==StudioXm does not find the BLE2SYS bluetooth interface when refreshing the interface list==
* Make sure bluetooth is switched on at your smartphone/tablet
* Make sure bluetooth is switched on at your smartphone/tablet.
* BLE2SYS uses bluetooth smart (bluetooth LE), make sure your mobile device supports this special bluetooth protocol
* Do NOT connect to the BLE2SYS device over the smartphone/tablet bluetooth menu, StudioXm establish connection by itself!
* BLE2SYS uses bluetooth smart (bluetooth LE), make sure your mobile device supports this special bluetooth protocol.
* Make sure the LED on the BLE2SYS flashes in intervals of 2 seconds. By default the interface deactivates after 30 seconds whe there is no connection. In this case the LED is off. You have to cylce power in order to reactivate the device.<br />
* Make sure the LED on the BLE2SYS flashes in intervals of 2 seconds. By default the interface deactivates after 30 seconds whe there is no connection. In this case the LED is off. You have to cylce power in order to reactivate the device.<br />
<br />
<br />