Bureaucrats, Administrators, translate-proofr
15,502
edits
Changes
Jump to navigation
Jump to search
Line 1:
Line 1: − + Line 7:
Line 7: − +
MICROBEAST does not finish initialization. What can I do? (view source)
Revision as of 20:07, 9 December 2013
, 10 years agono edit summary
* Watch the running LED lights during the init phase:
* Watch the running LED lights during the init phase:
If the lights A - G light up the sensor's rest positions are beeing calibrated. H - N show determining the RC channels and their center positions. Initially, the chase is from A - N. If a step is done, the light passes only between A - G or H - N. Can one step not be completed, either the unit is not receiving a valid signal or the MB was moved during the process (e.g. due to wind, vibrations, etc..).
If the lights A - G light up the sensor's rest positions are beeing calibrated. H - N show determining the RC channels and their center positions. Initially, the chase is from A - N. If a step is done, the light passes only between A - G or H - N. Can one step not be completed, either the unit is not receiving a valid signal or the MB was moved during the process (e.g. due to wind, vibrations, etc..).
* Only applies to Microbeast with firmware V2.0.0 and up:
* Only applies to Microbeast with firmware V2.0.0 and up:
Is the correct type of receiver selected in the receiver setup menu?
Is the correct type of receiver selected in the receiver setup menu?