Bureaucrats, Administrators, translate-proofr
15,511
edits
Changes
Jump to navigation
Jump to search
Line 111:
Line 111: + + + + + + + + + Line 118:
Line 127: + + + + + + + + + Line 171:
Line 189: + + + − − <!--T:22-->
no edit summary
= E - Rudder limit = <!--T:12-->
= E - Rudder limit = <!--T:12-->
Use rudder stick (hold or tap) to move servo to one endpoint. Wait until LED flashes, then move all the way to the other endpoint. Wait again until LED flashes. If stick direction is inverted, use servo reverse function on radio to reverse direction.<br />
Use rudder stick (hold or tap) to move servo to one endpoint. Wait until LED flashes, then move all the way to the other endpoint. Wait again until LED flashes. If stick direction is inverted, use servo reverse function on radio to reverse direction.<br />
<br />
'''Helicopters with tail motor'''<br />
<br />
When using the firmware with tail motor support, here you can set stop position of the tail motor. Tap or hold rudder stick to adjust output signal for tail motor ESC.<br />
<br />
Turn on the main throttle on the radio to start the tail motor. Now you can adjust the lowest possible running position for the tail motor using the rudder stick again. Set the motor speed to a low idle position just before the motor will quit. Then turn off main throttle and proceed to next step.<br />
<br />
<br />
<br />
2. Check LED color: right = blue and left = red. If LED color is incorrect, tap aileron/roll stick once to reverse LED color. Don't use reverse function on radio to change LED color! <br />
2. Check LED color: right = blue and left = red. If LED color is incorrect, tap aileron/roll stick once to reverse LED color. Don't use reverse function on radio to change LED color! <br />
<br />
'''Helicopters with tail motor'''<br />
<br />
1. Move rudder left/right and check LED color: right = blue and left = red. If LED color is incorrect, tap aileron/roll stick once to reverse LED color. Don't use reverse function on radio to change LED color!<br />
<br />
2. Turn on the main throttle on the radio to start the tail motor. Now you can adjust the start and hovering position for the tail motor. Tap or hold the the rudder stick and set the motor to a medium speed that will give a little push to the right, but not too much so the heli won't turn on the ground. Then turn off main throttle and proceed to next step.<br />
<br />
<br />
<br />
= N - Governor = <!--T:21-->
= N - Governor = <!--T:21-->
Tap rudder stick to select governor mode (change LED color). When not using the internal governor feature (Status LED off), setup will end here. When using electric or nitro governor, next menu step will be step A of GOVERNOR MENU.<br />
<br />
<br />
Note: Governor feature is only available for MICROBEAST PLUS / ULTRA at the moment.<br />
<br />
<br />
<br />
<br />
</translate>
</translate>