Changes

<br />

<br />

You can use nearly any radio system in combination with MICROBEAST PLUS. Due to the very different types of receivers with different types of signal output, you must setup the receiver type in the RECEIVER MENU.<br />

You can use nearly any radio system in combination with MICROBEAST PLUS. Due to the very different types of receivers and radio systems and their different types of signal output, you must setup the radio system in the RECEIVER MENU.<br />

<br />

<br />

Additionally when using a single-line receiver it is mandatory to define the function assignment for the receiver output channels. A single-line receiver bundles the control information to data packages or serialized electrical signals. So by default it is not clear, which channel controls which (stick) function.<br />

Additionally when using as socalled "single-line" receiver, it is mandatory to define the function assignment for the radio output channels. A single-line receiver bundles the control information to data packages or serialized electrical signals. So it is not clear, which channel controls which (stick) function.<br />

<br />

<br />

Since firmware version 5.4.x it is also possible to use a telemetry ESC. MICROBEAST PLUS processes the telemetry data and forwards it to the receiver. Again, there is a huge variety on the market and lots of different types of protocols are used. So it is necessary to setup the telemetry type as well, before you can use MICROBEAST PLUS with your radio system.<br />

Since firmware version 5.4.x it is possible to use a telemetry ESC. MICROBEAST PLUS can process the telemetry data and forward it to the receiver. Again, there is a huge variety on the market and lots of different types of protocols are used. So it is necessary to setup the type of telemetry input, before you can use MICROBEAST PLUS with your telemetry system.<br />

<br />

<br />

Finally when using a single-line receiver you have to set a failsafe position for the throttle channel. This defines at which position the motor is disabled and where to move the throttle in case the receiver is not sending any throttle signal, i.e. during power up or in case of loss of radio link.<br />

Finally, when using a single-line receiver you have to set a failsafe position for the throttle channel. This defines at which position the motor is disabled and where to move the throttle in case the receiver is not sending any throttle signal, i.e. during power up or in case of loss of radio link.<br />

<br />

<br />

{{QUOTE|By default the "Standard Receiver" is selected as receiver type. So if you're using this type of receiver and your MICROBEAST PLUS is brand new, you can skip this section as it is already setup correctly!}}<br />

{{QUOTE|By default the "Standard Receiver" is selected as receiver type. So if you're using this type of receiver and your MICROBEAST PLUS is brand new, you can skip this section as it is already setup correctly!}}<br />