Bureaucrats, Administrators, translate-proofr
15,511
edits
Changes
Jump to navigation
Jump to search
Line 1:
Line 1: + Line 5:
Line 6: + Line 14:
Line 16: − + Line 23:
Line 25: − + − +
Manuals:MBPlusFblV5:Governormenu B (view source)
Revision as of 13:17, 20 December 2017
, 6 years agoMarked this version for translation
<translate>
<translate>
<!--T:1-->
{{TOC_MBPlusV5}}
{{TOC_MBPlusV5}}
{{DISPLAYTITLE:Motor start position|noerror}}
{{DISPLAYTITLE:Motor start position|noerror}}
<br />
<br />
<!--T:2-->
GOVERNOR MENU point B is used to set the lowest throttle position. This is necessary for different reasons, i.e. the system must now where is the motor starting point when beginning the automatic spool up of the rotor when enabling the governor from standing still.<br />
GOVERNOR MENU point B is used to set the lowest throttle position. This is necessary for different reasons, i.e. the system must now where is the motor starting point when beginning the automatic spool up of the rotor when enabling the governor from standing still.<br />
<br />
<br />
<br />
<br />
=Adjustment on the device=
=Adjustment on the device= <!--T:3-->
When setting the low throttle position make sure the Status-LED lights up in <font color="#0066FF">'''blue'''</font> color (both electrical as well as nitro). This means that a new valid throttle position has been detected. If the Status-LED lights up in <font color="#FF3300">'''red'''</font> then the throttle stick is too close to the throttle stick center position. This is not considered optimal and therefore can not be used as throttle position. In this case check the setting of the transmitter and the programming of the speed controller or readjust throttle servo, carburetor position and throttle linkage rod.<br />
When setting the low throttle position make sure the Status-LED lights up in <font color="#0066FF">'''blue'''</font> color (both electrical as well as nitro). This means that a new valid throttle position has been detected. If the Status-LED lights up in <font color="#FF3300">'''red'''</font> then the throttle stick is too close to the throttle stick center position. This is not considered optimal and therefore can not be used as throttle position. In this case check the setting of the transmitter and the programming of the speed controller or readjust throttle servo, carburetor position and throttle linkage rod.<br />
<br />
<br />
<br />
<br />
=Setup with StudioX=
=Setup with StudioX= <!--T:4-->
<br />
<br />
<br />
<br />
<br />
<br />
=Setup with StudioXm=
=Setup with StudioXm= <!--T:5-->
<br />
<br />
<br />
<br />