GOVERNORMENÜ C - Vollgas Position

Bei Einstellpunkt "C" wird die höchste Gasposition festgelegt. Der Ausgang [CH5] wird hier nur im Modus "Verbrenner" direkt vom Motorkanal/Gassteuerknüppel angesteuert. Im Modus "Elektro" wird der Ausgang durch die zuvor eingestellte niedrigste Gasposition begrenzt. So kann die Vollgasposition gesetzt werden, ohne dass der Motor extrem weit hochläuft. Ansonsten gibt es an diesem Einstellpunkt keine Unterschiede zwischen Elektro- und Verbrennerheli.

Adjustment on the device

Move the throttle stick to full throttle position. The Status-LED must light up in blue color. This means that a new valid throttle position has been detected. If the Status-LED lights up in red the distance between the lowest throttle position and the full throttle position is too small. Since this will have a negative effect on the control behavior of the system, this throttle position can not be used. In this case check the setting of the transmitter and the programming of the speed controller or readjust throttle servo, carburetor position and throttle linkage rod. If necessary, set the lowest throttle position at menu point B again.

Similar to menu point B the Status-LED is off when entering menu point C. As long as you do not move the throttle stick, the currently stored position will not be changed. So you can skip menu point C by a brief push of the button without changing the throttle position when performing subsequent adjustments in Setup menu or Governor setup menu. Conversely this means that you need to move the throttle stick at menu point C at least once to change the current full throttle position!