Bureaucrats, Administrators, translate-proofr
15,511
edits
Changes
Jump to navigation
Jump to search
Line 20:
Line 20: − + Line 134:
Line 134: + Line 139:
Line 140: − |soft Line 154:
Line 154: − + + +
no edit summary
<br />
<br />
=Setup with StudioXm= <!--T:4-->
=Setup with StudioX= <!--T:4-->
Please note that editing parameters is only possible when the device has initialized completely. So as long as the system is not in operation mode the button to open the "Parameters" section is greyed out. If it does not pass initialization sequence check the device status shown in the middle of the screen. If the system does not finish "Receiver init" check the receiver settings and radio setup. If the system does not finish "Sensor init" make sure that it is perfectly standing still and that power supply is stable.<br />
Please note that editing parameters is only possible when the device has initialized completely. So as long as the system is not in operation mode the button to open the "Parameters" section is greyed out. If it does not pass initialization sequence check the device status shown in the middle of the screen. If the system does not finish "Receiver init" check the receiver settings and radio setup. If the system does not finish "Sensor init" make sure that it is perfectly standing still and that power supply is stable.<br />
<br />
<br />
<br />
<br />
{{TABLEV5|Throttle response
{{TABLEV5|Throttle response
|soft
|normal
|normal
|slightly increased
|slightly increased
|aggressive
|aggressive
|very aggressive
|very aggressive
}}<br />
}}<br />
<br />
<br />
}}<br />
}}<br />
<br />
<br />
With the StudioX software/StudioXm App you have the option to disable the softstart feature, which will set the spool up rate to "0". This is necessary when using a speed controler with built-in softstart feature (but without headspeed governing!). In this case the system will add half throttle immediately and wait until the speed controler has finished the spool up. Then it will activate the governing.<br />
With the StudioX software/StudioXm App you have the option to disable the softstart feature, which will set the spool up rate to "0". This is necessary when using a speed controler with built-in soft start feature (but without headspeed governing!). In this case the system will add half throttle immediately and wait until the speed controler has finished the spool up. Then it will activate the governing.<br />
<br />
{{WARNING_QUOTE|Please note that you can't set a speed lower than 50 rps with StudioX because of the fact noted above. Setting the speed below 50 will be the same as setting it to 0, so it will disable the soft start!}}<br />
<br />
<br />