7,261
edits
Changes
Jump to navigation
Jump to search
Line 18:
Line 18: − Please note that editing parameters is only possible when the device has initialized completely. If it does not pass initialization sequence check the device status from the status bar on the bottom. If the system does not finish "Receiver init" check the receiver settings and radio setup. If the system does not finish "Sensor init" make sure that it is perfectly standing still and that power supply is stable.<br /> − <br /> − Edit parameters in the software as necessary by either choosing the preset buttons or by clicking the "Customize" link. When using the bank switching feature (only with PROEDITION firmware) you can set parameters differently for the three flight modes/banks and switch between those different settings in flight. When bank switching is deactivated you can only set parameters for bank 1 as this is the default bank.<br /> − <br /> − <br /> − − =Setup with StudioXm= Line 138:
Line 131: + Line 143:
Line 137: − |soft Line 158:
Line 151: − + + +
Manuals:MBPlusFblV5:Parametermenu/en (view source)
Revision as of 11:47, 3 December 2018
, 5 years agoImporting a new version from external source
=Setup with StudioX=
=Setup with StudioX=
Please note that editing parameters is only possible when the device has initialized completely. So as long as the system is not in operation mode the button to open the "Parameters" section is greyed out. If it does not pass initialization sequence check the device status shown in the middle of the screen. If the system does not finish "Receiver init" check the receiver settings and radio setup. If the system does not finish "Sensor init" make sure that it is perfectly standing still and that power supply is stable.<br />
Please note that editing parameters is only possible when the device has initialized completely. So as long as the system is not in operation mode the button to open the "Parameters" section is greyed out. If it does not pass initialization sequence check the device status shown in the middle of the screen. If the system does not finish "Receiver init" check the receiver settings and radio setup. If the system does not finish "Sensor init" make sure that it is perfectly standing still and that power supply is stable.<br />
<br />
<br />
<br />
<br />
{{TABLEV5|Throttle response
{{TABLEV5|Throttle response
|soft
|normal
|normal
|slightly increased
|slightly increased
|aggressive
|aggressive
|very aggressive
|very aggressive
}}<br />
}}<br />
<br />
<br />
}}<br />
}}<br />
<br />
<br />
With the StudioX software/StudioXm App you have the option to disable the softstart feature, which will set the spool up rate to "0". This is necessary when using a speed controler with built-in softstart feature (but without headspeed governing!). In this case the system will add half throttle immediately and wait until the speed controler has finished the spool up. Then it will activate the governing.<br />
With the StudioX software/StudioXm App you have the option to disable the softstart feature, which will set the spool up rate to "0". This is necessary when using a speed controler with built-in soft start feature (but without headspeed governing!). In this case the system will add half throttle immediately and wait until the speed controler has finished the spool up. Then it will activate the governing.<br />
<br />
{{WARNING_QUOTE|Please note that you can't set a speed lower than 50 rps with StudioX because of the fact noted above. Setting the speed below 50 will be the same as setting it to 0, so it will disable the soft start!}}<br />
<br />
<br />