Changes

When initiating bind sequence you have to set whether you're using a DSMX or DSM2 satellite (the actual selected signal protocol in the transmitter is not relevant!). '''It is very important to choose the correct type of satellite receiver here, since an improper setting may seem to work but can lead to radio interference or total loss of radio linkage in the subsequent operation!'''</p>

When initiating bind sequence you have to set whether you're using a DSMX or DSM2 satellite (the actual selected signal protocol in the transmitter is not relevant!). '''It is very important to choose the correct type of satellite receiver here, since an improper setting may seem to work but can lead to radio interference or total loss of radio linkage in the subsequent operation!'''</p>

<p>

<p>

Insert a Spektrum® “Bind Plug” at the [SYS] port of MICROBEAST PLUS. In case the power is supplied exclusively at the [SYS] connection, to bind a Spektrum® satellite receiver the power supply must be provided temporarily through any of the other ports [CH1] - [CH5]. To bin a '''DSMX''' satellite simply switch on the power supply now. The LED on the receiver and LED '''H''' on MICROBEAST PLUS will start to flash. You can bind the transmitter as usual (for more information refer to the instructions of your radio control system). To select and bind a '''DSM2''' satellite, hold down the button on MICROBEAST PLUS while switching on the power supply. Now the receiver‘s LED and LED '''N''' (!) on the MICROBEAST PLUS will flash. Release the button and bind the receiver with your transmitter.

Um bei einem Spektrum® Einzelsatellit den Bindevorgang auszulösen, stecke den Bindestecker (Bind-Plug) an den SYS Anschluss. Wenn es sich um einen DSM2 Satellit handelt, drücke und halte den Taster bevor und während Du die Stromversorgung einschaltest. Am MICROBEAST PLUS blinkt die Menü LED N zusammen mit der LED am Satellit. Zum Binden eines DSMX Satelliten schalte nur die Stromversorgung ein, ohne den Taster zu drücken. In diesem Fall blinkt Menü LED H. Starte den Bindevorgang am Fernsteuersender. Entferne nach erfolgreichem Bindevorgang den Bindestecker.</p>

After successful binding procedure the receiver‘s LED will stay solid. LED '''H''' respectively '''N''' flash alternately to all other LEDs for 2 seconds, then MICROBEAST PLUS will enter receiver setup menu automatically as further setup steps may be required to use this type of receiver. Remove the bind plug and proceed with the setup as described in the following of this manual.</p>

{|cellspacing="20"

{|cellspacing="20"

|[[File:Spektrum_bind.png|x400px]]

|[[File:Spektrum_bind.png|x400px]]