Changes

2. Afterwards check the Status LED color and display in the software: on <span style="color: #4169E1;">'''positive pitch'''</span> the Status LED must be <span style="color: #4169E1;">'''blue'''</span>, on <span style="color: #DC143C;">'''negative pitch'''</span> it must light in <span style="color: #DC143C;">'''red'''</span> color. '''In case the display is inverted (red = positive and blue = negative), reverse the internal pitch direction of MICROBEAST PLUS by changing the direction in the software.'''<br />

2. Afterwards check the Status LED color and display in the software: on <span style="color: #4169E1;">'''positive pitch'''</span> the Status LED must be <span style="color: #4169E1;">'''blue'''</span>, on <span style="color: #DC143C;">'''negative pitch'''</span> it must light in <span style="color: #DC143C;">'''red'''</span> color. '''In case the display is inverted (red = positive and blue = negative), reverse the internal pitch direction of MICROBEAST PLUS by changing the direction in the software.'''<br />

<br />

<br />

If the stick is not moving far enough, you will see the message "Move stick to max. position! Check Status LED." In this case '''increase the servo throw/endpoint of the thrust channel in the transmitter for each direction just as far so that the Status LED changes from flashing to solid and the label disappears in the software when the stick reaches the end positions'''. (Note: Do not increase the endpoints too much in the transmitter. We need an exact match of full stick position and stick end position. So the Status LED should just change from flashing to solid when reaching the end position.)<br />

3. If the stick is not moving far enough, you will see the message "Move stick to max. position! Check Status LED." In this case '''increase the servo throw/endpoint of the thrust channel in the transmitter for each direction just as far so that the Status LED changes from flashing to solid and the label disappears in the software when the stick reaches the end positions'''. (Note: Do not increase the endpoints too much in the transmitter. We need an exact match of full stick position and stick end position. So the Status LED should just change from flashing to solid when reaching the end position.)<br />

<br />

<br />

3. Finally adjust the maximum collective pitch when the thrust stick is at full deflection for each direction using the adjustment boxes in the software.<br />

4. Finally adjust the maximum collective pitch when the thrust stick is at full deflection for each direction using the adjustment boxes in the software.<br />

<br />

<br />

{{QUOTE|Always set the servo direction in the transmitter first, then check the display on the MICROBEAST PLUS and change the internal control direction if it does not match the real direction. '''Do not change the internal direction in order to change the servo direction! This is only used for telling the system in which direction is up and down.''' Be very conscientious when doing this setup step as wrong direction will cause loss of control during rescue bailout and poor performance in general!}}<br />

{{QUOTE|Always set the servo direction in the transmitter first, then check the display on the MICROBEAST PLUS and change the internal control direction if it does not match the real direction. '''Do not change the internal direction in order to change the servo direction! This is only used for telling the system in which direction is up and down.''' Be very conscientious when doing this setup step as wrong direction will cause loss of control during rescue bailout and poor performance in general!}}<br />