If the stick is not moving far enough, you will see the message "Move stick to max. position! Check Status LED." In this case '''increase the servo throw/endpoint of the thrust channel in the transmitter for each direction just as far so that the Status LED changes from flashing to solid and the label disappears in the software when the stick reaches the end positions'''. (Note: Do not increase the endpoints too much in the transmitter. We need an exact match of full stick position and stick end position. So the Status LED should just change from flashing to solid when reaching the end position.)<br /> | If the stick is not moving far enough, you will see the message "Move stick to max. position! Check Status LED." In this case '''increase the servo throw/endpoint of the thrust channel in the transmitter for each direction just as far so that the Status LED changes from flashing to solid and the label disappears in the software when the stick reaches the end positions'''. (Note: Do not increase the endpoints too much in the transmitter. We need an exact match of full stick position and stick end position. So the Status LED should just change from flashing to solid when reaching the end position.)<br /> |