Bureaucrats, Administrators, translate-proofr
15,511
edits
Changes
Jump to navigation
Jump to search
Line 98:
Line 98: + + − − {{WARNING_QUOTE|When using telemetry, the '''control line of the speed controller must be connected to pin [IO1]!''' The cable for the telemetry signal is plugged into [IO2] instead.}}<br /> − Please note there are some additional settings for telemetry available:<br />+
no edit summary
| Scorpion® Tribunus ("UnSc" mode)
| Scorpion® Tribunus ("UnSc" mode)
|}<br />
|}<br />
{{WARNING_QUOTE|When using an ESC with telemetry at [IO2] port, the '''control line of the speed controller must be connected to pin [IO1]!''' }}<br />
<br />
<br />
<!--T:14-->
<!--T:14-->
'''There are some additional settings for telemetry available:'''<br />
* In GOVERNOR MENU you can use the '''signal divider''' and '''gear ratio''' adjustment to calculate the rotor head speed from the incoming motor speed. Most ESCs will send the electrical motor speed on the telemetry channel only, so you must divide the motor speed by the number of magnet pole pairs and by the main gear ratio of your helicopter, in order to display the rotor speed. See [[Manuals:MBULTRAFblV52:Governormenu_E/en|GOVERNOR MENU E]] and [[Manuals:MBULTRAFblV52:Governormenu_E/en|GOVERNOR MENU F]] for more details.
* In GOVERNOR MENU you can use the '''signal divider''' and '''gear ratio''' adjustment to calculate the rotor head speed from the incoming motor speed. Most ESCs will send the electrical motor speed on the telemetry channel only, so you must divide the motor speed by the number of magnet pole pairs and by the main gear ratio of your helicopter, in order to display the rotor speed. See [[Manuals:MBULTRAFblV52:Governormenu_E/en|GOVERNOR MENU E]] and [[Manuals:MBULTRAFblV52:Governormenu_E/en|GOVERNOR MENU F]] for more details.
* Some ESC do not calculate the current consumption (Hobbywing®, Kontronik® Jive). Here MICROBEAST ULTRA will do the work and calculate the current consumption using the instant current values. Anyhow, results may vary as speed controllers usually measure the motor current but not the battery current. So we added the parameter '''Capacity correction''' which allows to compensate the offset. I.e. when telemetry shows 3600mAh of current consumption, but in reality you did charge 4000mAh back into your battery after the flight, you can increase the Current correction by 10% to 110 in order to get proper reading the next time. Please note this very special value can only be set by using StudioX!<br />
* Some ESC do not calculate the current consumption (Hobbywing®, Kontronik® Jive). Here MICROBEAST ULTRA will do the work and calculate the current consumption using the instant current values. Anyhow, results may vary as speed controllers usually measure the motor current but not the battery current. So we added the parameter '''Capacity correction''' which allows to compensate the offset. I.e. when telemetry shows 3600mAh of current consumption, but in reality you did charge 4000mAh back into your battery after the flight, you can increase the Current correction by 10% to 110 in order to get proper reading the next time. Please note this very special value can only be set by using StudioX!<br />