7,261
edits
Changes
Jump to navigation
Jump to search
Line 7:
Line 7: − + + + − + + + + + + + + − + + + − + − <p> </p>+ + + + + +
Manuals:MB Plus:Preliminary steps/en (view source)
Revision as of 16:03, 12 November 2015
, 8 years agoImporting a new version from external source
<p>
<p>
The MICROBEAST PLUS unit can be attached '''flat or upright''' on the helicopter. However, the '''servo connector pins must always point towards the front or rear''' of the helicopter. The small white sensor pinboard on the side must always be inline with flight direction.</p>
The MICROBEAST PLUS unit can be attached '''flat or upright''' on the helicopter. However, the '''servo connector pins must always point towards the front or rear''' of the helicopter. The small white sensor pinboard on the side must always be inline with flight direction.</p>
<gallery widths="350" heights="300" mode="nolines">
<br />
<div class="noprint">
<gallery widths="400" heights="250" mode="nolines">
Image:450 flat.jpg
Image:450 flat.jpg
Image:450 upright.jpg
Image:450 upright.jpg
</gallery>
</gallery>
<p> </p>
</div>
<div class="onlyinprint">
{|
|[[Image:450 flat.jpg|x200px]]
|[[Image:450 upright.jpg|x200px]]
|}
</div>
{{NL}}
<p>
<p>
'''Pay attention that the edges of the Microbeast PLUS unit are all parallel with the corresponding rotational axes of the helicopter!''' Especially make sure that the mounting platform is perpendicular to the main shaft! On the other hand it is not important that the unit is directly placed on the rotation axis (which is nearly impossible).</p>
'''Pay attention that the edges of the Microbeast PLUS unit are all parallel with the corresponding rotational axes of the helicopter!''' Especially make sure that the mounting platform is perpendicular to the main shaft! On the other hand it is not important that the unit is directly placed on the rotation axis (which is nearly impossible).</p>
<gallery widths="500" heights="300" mode="nolines">
<br />
<div class="noprint">
<gallery widths="500" heights="250" mode="nolines" style="padding:5px 130px; ">
Image:Mounting_trex500.jpg
Image:Mounting_trex500.jpg
</gallery>
</gallery>
<div class="clear"></div>
</div>
<div class="onlyinprint">
{|
|[[Image:Mounting_trex500.jpg|x200px]]
|}
</div>
{{NL}}
<p>
<p>
'''There are eight possible mounting orientations:'''
'''There are eight possible mounting orientations:'''