Changes

The option “user defined” allows you to choose your own setting that can be edited by using the StudioX software bundle and the separately available USB2SYS interface.<br />

The option “user defined” allows you to choose your own setting that can be edited by using the StudioX software bundle and the separately available USB2SYS interface.<br />

<br />

<br />

Now plug in the swashplate servos, but do not install the servo horns yet as the servos could bind and get damaged on first power up.

Now plug in the swashplate servos, but do not install the servo horns yet as the servos could bind and get damaged on first power up:

[[Image:Swashtypes.png|thumb|400px|left]]

Image:Swashtypes.png

<br />

In slot CH1 is the elevator servo.<br />

</gallery>

With electronic swashplate mixing the two aileron servos have to be connected to CH2 and CH3 (the left/right ordering does not matter).<br />

In slot CH1 is the elevator servo. With electronic swashplate mixing the two aileron servos have to be connected to CH2 and CH3 (the left/right ordering does not matter). With a mechanical mixed head (H1) the aileron servo connects to CH2 and collective pitch servo to CH3.<br />

With a mechanical mixed head (H1) the aileron servo connects to CH2 and collective pitch servo to CH3.<br />

<br />

<br />

{{QUOTE|When you route the wire leads in your model make sure that there is no tension passed to the MICROBEAST PLUS. Make sure that MICROBEAST PLUS is able to move freely, so no vibrations get passed onto the unit by the wire leads. It is not recommended to bundle or tie down the leads close to the MICROBEAST PLUS. On the other hand the wires must be attached so that they are unable to move the MICROBEAST PLUS during the flight caused by g-force. In particular, do not use any shrink tubing or fabric hose to bundle or encase the wiring in close proximity to the point at which the cables are plugged into the MICROBEAST PLUS. This makes the cables stiff and inflexible and can cause vibrations being transmitted to MICROBEAST PLUS.}}

{{QUOTE|When you route the wire leads in your model make sure that there is no tension passed to the MICROBEAST PLUS. Make sure that MICROBEAST PLUS is able to move freely, so no vibrations get passed onto the unit by the wire leads. It is not recommended to bundle or tie down the leads close to the MICROBEAST PLUS. On the other hand the wires must be attached so that they are unable to move the MICROBEAST PLUS during the flight caused by g-force. In particular, do not use any shrink tubing or fabric hose to bundle or encase the wiring in close proximity to the point at which the cables are plugged into the MICROBEAST PLUS. This makes the cables stiff and inflexible and can cause vibrations being transmitted to MICROBEAST PLUS.}}